xboxscene.org forums

Author Topic: Problems With Duo X2  (Read 65 times)

HackDaBox

  • Archived User
  • Hero Member
  • *
  • Posts: 885
Problems With Duo X2
« on: November 11, 2005, 10:54:00 PM »

OK your original problem was most likely that when you soldered the BT wire to the point behind the eject button it was hitting on the metal shield around it but jumpering the 2 points was not the right course of action !

Remove the BT wire from behind the eject button and re-test the xbox. Does the eject button work now ? if not remove the modchip and bt and d0 ... only leave the headerpin installed. and retest and report back here !

If the eject button works fine now then solder the BT wire to the alternate pont onthe bottom of the motherboard ( leave the area behind the eject button alone with nothing connected to it )

Here is the BT point for older motherboards !
user posted image

Here is the BT point for V1.6 motherboards !
user posted image

Check out my DuoX2 install and flashing guides at www.HackDaBox.com

HackDaBox !

Logged

HackDaBox

  • Archived User
  • Hero Member
  • *
  • Posts: 885
Problems With Duo X2
« Reply #1 on: November 13, 2005, 09:22:00 AM »
search ebay for a new power/eject panel. Search the tutorials on xbox-scene for a power led replacement as it has instructions on how to access the power/eject switch and you can replace it !

Maybe try swapping yours with a mates forst to see if that fixes the problem !

HackDaBox !
Logged