xboxscene.org forums

Author Topic: Problems With V1.0 And Duox2 (white) Mod  (Read 83 times)

hippo

  • Archived User
  • Sr. Member
  • *
  • Posts: 497
Problems With V1.0 And Duox2 (white) Mod
« on: August 13, 2005, 06:01:00 PM »
If the led on the chip never goes active check ground, power, or BT. If the LED on the chip is active and you find yourself in MS mode check D0.
Logged

HackDaBox

  • Archived User
  • Hero Member
  • *
  • Posts: 885
Problems With V1.0 And Duox2 (white) Mod
« Reply #1 on: August 13, 2005, 08:02:00 PM »

Use a multimeter on VOLTS DC. Black probe on pin 2 Ground and Red probe on pin 9 ( 3.3v ). If you dont get close to 3.3 volts then you have a problem !

Follow this Duo X2 Troubleshooter i made ...

Duo X2 Troubleshooter!

HackDaBox !

Logged

LepPpeR

  • Archived User
  • Hero Member
  • *
  • Posts: 1681
Problems With V1.0 And Duox2 (white) Mod
« Reply #2 on: August 13, 2005, 08:22:00 PM »
what about the BT point?  is that soldered correctly?
Logged

Chancer

  • Archived User
  • Hero Member
  • *
  • Posts: 5751
Problems With V1.0 And Duox2 (white) Mod
« Reply #3 on: August 14, 2005, 07:34:00 AM »
You can check if the D0 is correct by simply running it to ground. the box should fRAG as the chip LED is not lit.
The problem would seem to be on the LPC. As stated Pin 9 should have 3V3
Its is likley if you used a pinheader that you did damage to the lPC removing the solder in the holes as its a V1
Logged