Print

[HackDaBox]

OK well first remove the mobo and recheck for small tiny balls of solder that have accidently fell on the board !

 Now re-do all the solder points again adding a little extra solder to each point and hols each wire steady for a few seconds after you remove the soldering iron to it sets properly.

make sure the switch is on bank one !  but the problem you are describing is allmost defenently a soldering problem even though your soldering may look ok to your naked eye !

HackDaBox !

[Gianmarco]

Ok I'll try to resolder if it is the only way to get my Xbox back on the road !

I tried both banks but nothing changed...still frag !