xboxscene.org forums

Author Topic: First X-lite, 1.6 Mod Attempt  (Read 79 times)

christineyoung

  • Archived User
  • Sr. Member
  • *
  • Posts: 307
First X-lite, 1.6 Mod Attempt
« on: May 18, 2005, 12:16:00 PM »
Verify you do not have a pin header in the two spots you are not suppose to have.

As well, telephone wire should work, just make sure no wire crosses each other ( aka ontop of each other )

As well if fragging means you have LFRAME connected right, and if LED's means 5V is connected right.

Make sure you also have all pins on pin header soldered as well.
Logged

rasdude

  • Archived User
  • Newbie
  • *
  • Posts: 1
First X-lite, 1.6 Mod Attempt
« Reply #1 on: May 20, 2005, 08:19:00 AM »
Oooh, a change in behavior!

After soldering the other pins in place, it now frags only when I have the X-lite enabled (dip #1 set to "on"), and it boots up to the MS dashboard when it's disabled.  This is a change to how it was previously when having the X-lite plugged into the pin header caused it to frag every time, independent of the dip switch settings.

Any more ideas?
Logged

VOIP_71

  • Archived User
  • Newbie
  • *
  • Posts: 4
First X-lite, 1.6 Mod Attempt
« Reply #2 on: May 25, 2005, 12:11:00 PM »
blink.gif
Logged