Topic: Xbit External Cable/dip Switch/usb Board? (Read 65 times)

FunkmaztafoX · « **on:** February 06, 2004, 05:04:00 PM »

i just left mine to dangle.

jeepers94 · « **Reply #1 on:** February 07, 2004, 08:41:00 AM »

I also used Velcro,but I do think DMS should have used shrink tubing on the yellow and black wires! It would look a (x) bit better.I was going to drill a hole in the case to make a cleaner install,but my system is under warranty,and with the pogo pins and Velcro,I can put it back to original if I have to.

kaarde · « **Reply #2 on:** February 07, 2004, 05:02:00 PM »

Velcro works good, but you could just drill holes in the case and screw it too. put some rubber spacers between the board and the box and you're good to go

kabammi · « **Reply #3 on:** February 09, 2004, 09:14:00 PM »

Author Topic: Xbit External Cable/dip Switch/usb Board? (Read 65 times)