Topic: Matrix + V1.0 Xbox + V4983 Bios = Nothing (Read 78 times)

Exzir · « **on:** September 08, 2004, 04:32:00 AM »

What are the dip switche settings currently.
How are you aligning the chip
Have you tried cleaning the d0 and lpc

alorlious · « **Reply #1 on:** September 08, 2004, 06:57:00 AM »

I set them to write mode (1off 2off) to write and then to 1 off 2 on when in the XBOX. The light on the chip is solid green when powered on. I align the chip manually and then plug it in prior to re-installing the HDD & DVD drives.

I have not cleaned anything yet.

I will try that tonight, thanks!

alorlious · « **Reply #2 on:** September 08, 2004, 11:45:00 AM »

I cleaned the d0 and the LPC. I also cleaned the pogo-pins themselves. I used a wire wheel on a dremel at a very low speed. The points are much shinier but I still have the same results.

Any more ideas?

alorlious · « **Reply #3 on:** September 08, 2004, 06:02:00 PM »

I fixed it. I had the screw in the chip too tight. Apparently the green LED on the chip isn't always a sure fire sign that you have the chip installed correctly. After moving the chip around a few times I started getting the XECUTER2 logo during bootup.

Thanks!

Exzir · « **Reply #4 on:** September 08, 2004, 07:37:00 PM »

Ok will remember that for the next time someone asks.

Author Topic: Matrix + V1.0 Xbox + V4983 Bios = Nothing (Read 78 times)