Topic: Chameleon And Xbox 1.5 Problem (Read 127 times)

Infamous · « **on:** February 06, 2004, 11:57:00 AM »

forgot to mention, this is my first time working with the 1.5 xbox.

ofx210p · « **Reply #1 on:** February 06, 2004, 12:35:00 PM »

Have you made the wiring modifications to the xbox before installing the pinheader ?

If you need help email me

Cheers

Chris

oo7texas · « **Reply #2 on:** February 06, 2004, 09:09:00 PM »

same problem here...i just installed a chameleon on a 1.2 and i had absolutely no problems but i tried putting one in a 1.5 and i get the factory settings and bios...no cromwell screen. can someone email me the wire modifications as well. thanx.

ytsejam · « **Reply #3 on:** February 07, 2004, 04:14:00 AM »

On a 1.5 Xbox you need to do the following:

Xbox 1.5 Wire diagram

You don't need the 3.3V wire just the ground

Infamous · « **Reply #4 on:** February 07, 2004, 10:18:00 AM »

yea i would like to know that same question as well, and also, are you sure that i only need to do the ground wire?

ytsejam · « **Reply #5 on:** February 07, 2004, 03:21:00 PM »

Yes you can solder it to the pogo pin and I am sure you only need the ground wire.

ofx210p · « **Reply #6 on:** February 09, 2004, 02:57:00 AM »

The solderless adaptor also comes with a set of small rivets that you push into the holes to make a better contact If you havent any PM me.

You shouldnt be using the solderless adaptor without them on the non filled lpc versions of the motherboard.

Author Topic: Chameleon And Xbox 1.5 Problem (Read 127 times)