Topic: Another F*cked Xbox ... (Read 86 times)

moistness · « **on:** September 25, 2003, 07:33:00 AM »

drill it right through and use a nut and bolt instead!

slappy00 · « **Reply #1 on:** September 25, 2003, 08:19:00 AM »

Hes right drill it or try and find a tap and dye kit to make a slightly larger hole that is threaded... i think nut and bolt is the best idea in this situation

upstartmike · « **Reply #2 on:** September 25, 2003, 09:51:00 AM »

guys ... thanks a lot .. that definatly sounds like the plan .

Now one more concerning issue about this ... I was tryin to see if it would by holding it in place with my hand and turning the xbox on . (i did this with the chip set to 'on' ) and when I got a green lgiht... I heald it in place, turned it on and it still displayed that error screen saying 'your xbox is fucked.. you need repairs .. eror 16 .. ra ra ra'

was I retarted to try this? and is there a reason it wasn't working even though I had a green light on the matrixchip ??

thanks again everyone.

loupham · « **Reply #3 on:** September 25, 2003, 09:59:00 AM »

If u don't want to drill right thru your box. Here's how i did mine. Take off the motherboard and put a screw from thru the mb thru the bottom ... screw mb back and you can use a nut to screw down the matrix from the top ...

upstartmike · « **Reply #4 on:** September 25, 2003, 10:04:00 AM »

wicked idea
thanks for the help amigos.

GomerPyle · « **Reply #5 on:** September 25, 2003, 04:03:00 PM »

Or just use your head and Get a Bigger screw (fatter)

Wham good as new!!!

Haru78 · « **Reply #6 on:** September 26, 2003, 04:16:00 PM »

Get a Mig welder and plasma torch and fix that puppy!

PhantomX · « **Reply #7 on:** September 26, 2003, 04:20:00 PM »

That would surly fix it, but for the cost of getting that, I am sure it would be easier just to buy another system.

Author Topic: Another F*cked Xbox ... (Read 86 times)