Topic: Chameleon Quick Solder... (Read 80 times)

jonathan55657 · « **on:** September 21, 2003, 01:15:00 PM »

I paid for nothing. so I go to the store to buy a solder kit . and I solder the main LPC points and the D0. the xbo frags. I check them again to make sure contact is there... I am sure, I tri to change the switches, xbox frags... and the light of the chameleon doesn't light up...

PLEASE HELP!!! ANY help would be appreciated thanks...

jonathan55657 · « **Reply #1 on:** September 21, 2003, 01:51:00 PM »

Can someone give me a hand please??

Any help would be appreciatted. Thank you

jonathan55657 · « **Reply #2 on:** September 21, 2003, 04:11:00 PM »

Maybe its a bad chip or... If anyone has an idea... please suggest it

thank you

jonathan55657 · « **Reply #3 on:** September 22, 2003, 06:00:00 AM »

Does anybody has an idea? I will try to get a picture of it and let's see what will happen...

mirx999 · « **Reply #4 on:** September 22, 2003, 01:43:00 PM »

it seems you may have damaged something, make sure you're not shorting anything. also, try removing the chip and see if it boots.

Kazaki · « **Reply #5 on:** September 22, 2003, 02:06:00 PM »

. Much easier then trying to screw AND hold it. Oh, I felt stupid when this happened, but... make sure you don't put the cham on the adapter backwords... omg... I still remember my first time...

I've done about 4 Xboxes with this method, worked on the first try every single time.

slappy00 · « **Reply #6 on:** September 22, 2003, 07:23:00 PM »

jonathan55657 · « **Reply #7 on:** September 23, 2003, 04:47:00 AM »

Kazaki · « **Reply #8 on:** September 23, 2003, 12:44:00 PM »

Make sure you have the gold plated wire in the D0 point. What me and my friends do is get it in there, push down on the wire a tad bit, and kinda tap the case to make sure it's in good.

I don't understand why people have so much problems with it... make sure you push down hard on the adapter as you screw it in... hell, look at the adapter from the sides when aligning (the Xbox case is semi-see-through from the sides with no lid anyways) and make sure you keep it there good and pressed down as someone screws it in tight for you.

Author Topic: Chameleon Quick Solder... (Read 80 times)