Print

[viscious07]

QUOTE

Posted on Aug 25 2003, 06:31 PM -------------------------------------------------------------------------------- QUOTE (Kazaki @ Aug 24 2003, 02:40 AM) With the solderless adapter, do you still have to solder in the P and E points to use the mode 4 functions? Do you need to solder P and E points to use the eject trick that turns off the mod? Thanks  you'll need to solder in P/E even with the solderless adapter

umm...no u don't...u can disable the mod and boot from ms dash through evox...u dont need to solder p/e!!

[dem0n2001]

hey i set up the mod chip yesterday and took a 1mb bios and used the bios split program in tool secton to get it down to 256k. I inserted it into the xbox when then bios asked me for it. it said it was good and accepted it , turned itself off(reboot) and now its just black. I cant even get the xbox dash to come up.....anybody can help me?

[Kazaki]

QUOTE

hey i set up the mod chip yesterday and took a 1mb bios and used the bios split program in tool secton to get it down to 256k. I inserted it into the xbox when then bios asked me for it. it said it was good and accepted it , turned itself off(reboot) and now its just black. I cant even get the xbox dash to come up.....anybody can help me?

 Wha? I didn't know that's possible... to me, taking a 1MB bios and making it 256k sounds like you cut out a bunch of its code.

Maybe that's the problem?

And are you using Matrix or Chameleon? Cause if Chameleon, you coulda just used Mode 3.

[dem0n2001]

im using a chamelon and i had it set to the factory default like it was said to do in the instruction boox...i used the tool bios slicer in the tools section....  help

[Kazaki]

  You could wait for someone elses advice or you can try reflashing it-from my understanding, there's a cromwell bios in each bank in mode 1.