Topic: Matrix And Chameleon (Read 225 times)

Mast3r Ch13f · « **Reply #15 on:** August 05, 2003, 06:57:00 PM »

DJ Hoyt, you are a fu<kin' idiot (plain and simple). It was mentioned 2 or more times (once by myself) on this very topic AND YOU ARE STILL ASKING THE SAME QUESTION!!!!!!

Maybe instead of taking that electronics course in college, you should have applied for the Critical Thinking course.

ALLOW ME TO REPEAT IT AGAIN!!!!!!!!

With the solderless adapter, it WILL BE SOLDERLESS!!!!

If you're using the solderless adapter and want to go onto XBlive you NEED TO SOLDER 2 WIRES, so the chip can be disabled (there is no stealth mode, this is not a PS1).

The reason for a Matrix and a Chameleon combo was to make the Chameleon solderless, but now since there is the solderless adapter, there is no need for this combo.

DJ Hoyt · « **Reply #16 on:** August 06, 2003, 08:45:00 AM »

Excuse you? That was really uncalled for. Anyways, now that you've explained it clearer, I get it. But when you solder these two wires to disable it the chip, how do you undo that if you want to enable the chip again? And yes, stealth mode was mentioned in the ad for the Chameleon. Here is a direct copy paste from the user manual PDF. I am not an idiot, I've just read a lot of information.

Mode 2 (2x512 + Stealth)
The flash space of the Chameleon is split into 2 equal parts of 512k each. Again you can pre select your desired boot bank by setting the bank dip switches. A special case is entered into when Dip 4 is turned ON, this is Stealth Mode, here the on board controller of the Chameleon will boot from Bank 1 and then switch over to Bank 2 automatically. Thus the only bios that can be seen after boot is the one in Bank 2.

This is what I meant by stealth mode, but it looks like it doesn't refer to live, but I at least proved you wrong in one area that there is a stealth mode.

I also heard you could disable the Chameleon so it couldn't be seen by xbox live by using EvoX. Do you know anything about that?

No_Remorse_666 · « **Reply #17 on:** August 06, 2003, 02:19:00 PM »

DJ Hoyt · « **Reply #18 on:** August 06, 2003, 02:42:00 PM »

It's cool people like you that really help =) Thanks! Now, where could I get this code to add to the evox program? If it's on xbox-scene.com, could I get the link to the tutorial? Because if I could just install the chameleon, seal my xbox, and forget about it, that would be great =)

blackbishop · « **Reply #19 on:** August 10, 2003, 01:26:00 AM »

Yes it does have stelth mode. just set the dip switch and then your off playing Live games

GREGWILLRULEYOU · « **Reply #20 on:** August 12, 2003, 02:13:00 PM »

send your xbox to rustydog and get one installed for 60(including the chip)

Author Topic: Matrix And Chameleon (Read 225 times)