Topic: The Matrix Mod Chip. (Read 61 times)

SBEEZY · « **on:** July 13, 2003, 06:10:00 PM »

first off tell me something do u have solder in your lpc ports and do u have the matrix in mode 1 (both switches off)

monkey x 187 x · « **Reply #1 on:** July 13, 2003, 06:22:00 PM »

u dont have to solder and what u mean both off?

No_Remorse_666 · « **Reply #2 on:** July 13, 2003, 06:32:00 PM »

he is trying to ask you if the LPC holes on your Xbox are filled with solder or not.
If you have a version 1.0 then they are most likely filled.
he also asked what mode your matrix was in. Mode 1 is for alignment.

No_Remorse_666 · « **Reply #3 on:** July 13, 2003, 06:45:00 PM »

you can try and scrape the D0 point very softly with and xacto knife.
When you visualy line it up by the holes in the matrix chip, make sure your looking straight down at it.

Xeero · « **Reply #4 on:** July 13, 2003, 07:17:00 PM »

QUOTE (monkey x 187 x @ Jul 13 2003, 10:52 PM)

the tape wont hold the washer down could i use a nother oice of tape?

What the...? The screw should be enough to hold the washer down...

Xeero · « **Reply #5 on:** July 13, 2003, 07:24:00 PM »

Okay. What tape were you talking about??

Xeero · « **Reply #6 on:** July 13, 2003, 07:34:00 PM »

You should have flashed your Matrix before you installed it. You can use the programmer that came with the mod.

monkey x 187 x · « **Reply #7 on:** July 14, 2003, 05:26:00 AM »

Author Topic: The Matrix Mod Chip. (Read 61 times)