Topic: Did I Fry My Matrix Chip?!?! (Read 88 times)

xero2k · « **on:** June 24, 2003, 12:22:00 AM »

finally its programming, ill update in a min

MrCodeDude · « **Reply #1 on:** June 24, 2003, 12:30:00 AM »

-- mrcodedude

xero2k · « **Reply #2 on:** June 24, 2003, 12:50:00 AM »

well now I put the naoni red 256 on there and it starts up, then resets 3 times
and then nothing, DAMNIT whats wrng??!!?

xero2k · « **Reply #3 on:** June 24, 2003, 01:01:00 AM »

And NOW it wont read on the LPC anymore... SHIT now I gotta buy another chip...maybe.... suggestions?

Anguished_Oink · « **Reply #4 on:** June 24, 2003, 06:12:00 AM »

No suggestions....sorry.......But, I am interested in what (EXACTLY) you did when it started smokin?

garak112 · « **Reply #5 on:** June 24, 2003, 08:23:00 AM »

Out of interest did you plug the programmer into the chip whilst connected to the pc (which is on)., because you arnt supposed to do that. The programmer and chip should always be connected before plugging into the printer port and I usually do it while the pc is off for safety.

xero2k · « **Reply #6 on:** June 24, 2003, 12:00:00 PM »

LOL, oops.... well it programmed again last night, I put my old bios on now I have to test it, Ill let u guys know

rzyzzy · « **Reply #7 on:** July 01, 2003, 12:50:00 AM »

badrc · « **Reply #8 on:** July 04, 2003, 11:29:00 AM »

i made my matrix smoke when trying to realign it after it came off. I connected it to my pc and it did not detected. I looked at the chip closely and noticed that a trace was burned. I kinda stretched it to the other end where it was supposed to be connected and taped it up. (did not have a soldering iron). I put the chip in and pc detected it. not only thing holding it together is Scotch tape, but it still works. .

Author Topic: Did I Fry My Matrix Chip?!?! (Read 88 times)