Print

[XzibitX]

QUOTE

i know there is current passing cause when i put my tongue on the programmers end i get a shock

But ya, computers often have problems with programmers because it has to be at certain settings. What i would do bro is flash the chip with evo-x. Set it to write mode(flashing orange) and boot evolution-x and transfer the bios into the c:bios folder then reboot, then go to settings, flash bios, select your bios of choice and boom....takes 5-10seconds and done:) If the programmer wants to give attitude then burn it:)

[DgtHorse]

I dont remember what i flashed my Modchip with last but will i be able to write to it anyway no matter what? I do not have a DVD burner only a CD-R...will that work if i boot from the cdr?

[nickia]

yes

[rms2001]

You just burn EvoX to the disk
But your XBox will not boot a CD-R unless you have a Samsung DVD-Rom in it. Use a CD-RW.

[DgtHorse]

Ok i burned it using xISO i think it should be ok but when i boot my xBox in mode4 "Write Enable" the system resets twice and stays on afterwards with the red/green flahing on xBox. Is something wrong?

[Terragen]

QUOTE (DgtHorse @ May 27 2003, 03:26 PM)

Ok i burned it using xISO i think it should be ok but when i boot my xBox in mode4 "Write Enable" the system resets twice and stays on afterwards with the red/green flahing on xBox. Is something wrong?

My cousin had this problem when we installed his matrix.. we had to freshen the LPC points and also install external switches. I remember there being a bit of solder shorting something out.. either on one of the LPC pogo pins or the LPC points themselves.. did you solder anything? check to make sure everything looks ok..

because when it was shorted it did the reset twice thing as well.. removed the solder and cleaned it up and all is well now though

[DgtHorse]