xboxscene.org forums

Pages: 1 [2]

Author Topic: Matrix Eats It  (Read 234 times)

King_Nothing

  • Archived User
  • Newbie
  • *
  • Posts: 26
Matrix Eats It
« Reply #15 on: April 25, 2003, 09:38:00 PM »
SUCCESS!!! it finally works! thanks to all of you sooo damn much. Y ou're all my heroes. couldnt have done it without ya.

to those out there still struggling i put up a topic on all that i had to do to get it to work

http://forums.xbox-s...=ST&f=9&t=48898
Logged

soccer3

  • Archived User
  • Newbie
  • *
  • Posts: 1
Matrix Eats It
« Reply #16 on: July 31, 2003, 05:37:00 PM »
What wattage of a soldering iron did you use?  Also what size solder did you use? wink.gif   I have a v1.1 w/ a Matrix.  The lpc holes are hollow on the board.  With both switches on during installation, the chip was aligned to where it would flash green and then go red.  Supposedly that is when it is aligned, but when one is up and two is down, there is no video.  The chip flashes green 3 times and then it stops because it errors.  Tried installing it for hours, but it still wouldn't work.  Tried installing it on a friend's box with filled holes and it worked.  How do you fill the holes?  again, what wattage of iron did you use?  What size solder did you use?
Logged

musical_mercenary_420

  • Archived User
  • Full Member
  • *
  • Posts: 120
Matrix Eats It
« Reply #17 on: July 31, 2003, 05:50:00 PM »
really u should have gotten a x2lite/plus
Logged
Pages: 1 [2]
« previous next »