Topic: Help Aligning V1.1 (Read 138 times)

foph82 · « **on:** April 14, 2003, 11:23:00 PM »

I am having the same problem as you. I started installing my matrix modchip today and I haven't had any luck. When I put it in mode 1 the light always stays on red and never turns green. When I put the modchip in mode 2 the light stays constant green, but none of the backups I have work. I also have a version 1.1 xbox. I've only used the Cromwell 1.8 Linux Bios so far. I am going to try the evox bios tomorrow to see if that will work. Let me know if you figure it out.

GuySmily · « **Reply #1 on:** April 14, 2003, 11:43:00 PM »

(As posted on the ModChip Chat)

Take something sharp and pointy (like a knife) and put the point of it into d0, then just scrape and scrape until d0 is nice and shiny. I put the knife in and just spun it around while applying pressure. Just don't put too much pressure, or slip and cut the board. I had to do this for both 1.0 and 1.1 xboxes to get my matrix chips to work.

VvBroncovV · « **Reply #2 on:** April 15, 2003, 12:47:00 PM »

I just wanna get this straight....are you saying we should fill in the d0 hole with solder? What exactly would that do? just curious on what effect it will have before I fill it. Thanks for the replies!

tien1728 · « **Reply #3 on:** April 15, 2003, 01:13:00 PM »

I just install a matrix on my xbox on a 1.1 .. My problem was the bio i flash with a x2 bio didn't work ... and when i flash with a evox d6 blue... works... and algining it take alot of time for me i watch the video that easybuy2000 has on the site where the women align it and i just screw it down tight enough so that i see a red flash then move it around to see if green flash and it does i screw it down tighter... took me 10 mins.... hope this helps

FIREitUP · « **Reply #4 on:** April 15, 2003, 04:23:00 PM »

lol @ tien's signature HAHAHAHAHAHAHAHAHAHAHAHAHAHA OMG THATS FUNNY SHIT
dude did you try my method??

VvBroncovV · « **Reply #5 on:** April 16, 2003, 04:03:00 PM »

hypr-x · « **Reply #6 on:** April 16, 2003, 04:27:00 PM »

QUOTE (VvBroncovV @ Apr 17 2003, 12:03 AM)

.... (I didnt get a green light at all just blinking red). Then stuck in mode 2 and it loaded one of my backups.

So you didn't even get the brief flash of green whilst in mode 1, just red... and you got it to work??? I thought this indicated an incorrect alignment of the matrix with respect to d0.

foph82 · « **Reply #7 on:** April 16, 2003, 04:42:00 PM »

Where is the d0 hole located? Is it on the top of the matrix in the middle of the alignment holes?

Author Topic: Help Aligning V1.1 (Read 138 times)