Print

[apw100]

I installed a flashed Matrix chip in my XBOX with the EvoX D.6 color(blue) modded BIOS, but it doesnt seem to recognize it.   The Matrix is installed correctly(green light) so that cant be the problem.  When I turn the XBOX on, it boots up just like before I modded it.  With the color mod BIOS, shouldnt the "X" on the logo change color(blue rather than green)?  Please help!!!

[daymatrix]

I have the same problem, my xbox behaves the same after I installed my modchip, although everything seemed to go right.
But I've got v.1.0 xbox, and a matrix chip from the new shipment from easybuy

[sharpie00]

sharpie00

[apw100]

I finally fixed the problem.  One of the pogo pins on my Matrix chip wasnt alligned correctly. Here's what I did....
1. Make sure your Matrix chip is flashed with the bios and set to Mode 1(both switches in the "ON"
   position.
2. Install the Matrix into your XBOX.  Look closely to make sure that the connectors are lined up
   correctly. I had to gently pull the chip towards me (the front of the XBOX) as I was screwing it in
   for the pins to line up correctly.  Screw the chip in so that its snug but able to be moved slightly
   to either side.
3. Turn on your XBOX.  If the Matrix has a flashing green light, then its alligned properly.  If it
   flashes red, you will have to make some adjustments.  With the XBOX still on, slowly(millimeter
  by millimeter) and carefully move the Matix chip from side to side until you see a flashing green
  light.  This may take a few tries.
4. Once you see the flashing green light, tighten the screw that is holding the Matrix in place until
   the chip is firmly in place(not too tight!) Hopefully, the pins will still be alligned(green flashing
   light) after you tighten the screw If not, start at step 3 again....
5. Turn off your XBOX.  
6. Now that your Matrix is alligned, you can use the switches to change to the mode of your
   choosing.  I used Mode2(Matrix always on).
7. Turn on your XBOX
8. If your Matrix was flashed with EvoX D.6 colormod, then after the opening animation, the "XBOX"
   and "X" logo should turn either red or blue(depending on which colormod you chose).  Now you
   have successfully installed your Matrix chip. Now go to the next step.
9. Figure out how to burn and install EvolutionX.... and then tell me how to do it!  Its killing me!  

[sharpie00]

sharpie00

[FIREitUP]

i have SlaYers_EvoX_Auto-Installer_v2.0_FINAL does that have evox that will make the xbox startup blue/red??

[Motocrossman]

Can u e-mail me where u got your bios for that chip.
I can't find them anywhere.
My e-mail address is [email protected]
thanks guys

[josan]

I have the EvoX.D.6.blue.bin is this a good bios? What version xbx will it work with?
And as for the matrix mod, is is same to use xbx live if the mod boots with the original xbx bios??