xboxscene.org forums

Author Topic: Problem With Matrix  (Read 143 times)

Zer04evr

  • Archived User
  • Sr. Member
  • *
  • Posts: 303
Problem With Matrix
« on: March 28, 2003, 08:36:00 PM »
you are not makin a connection with the d0 point
i had the same prob

the way i fixed it was i desoldered the other points and let the chip sit on the d0 point to find the point refer to the highres pic on the xbox-scene site but just make sure it makes the connections with all of the points or else that will continue so good luck alright
Logged

MeLv

  • Archived User
  • Newbie
  • *
  • Posts: 19
Problem With Matrix
« Reply #1 on: March 29, 2003, 05:25:00 AM »
i still have the same problem. i filled the LPC holes of the xbox with tin and i cleaned the pogopins and the d0 with alcohol but nothing changes. the bitch still reboots 3 times and then flashes green/red and no screen or it just boots from the original bios (martix on mode2). when i turn the matrix in mode1 (testmode) it boots the original bios (led on matrix blinks green one time and then red).

i have xbox 1.1/matrix/evoxd6 noani bios

think i'm gonna solder a wire from the d0 to the chip since that seems 2b my last hope.
Logged

Novahux

  • Archived User
  • Sr. Member
  • *
  • Posts: 449
Problem With Matrix
« Reply #2 on: March 29, 2003, 08:03:00 AM »
QUOTE
cleaned the pogopins and the d0 with alcohol but nothing changes


Use a fiberglass pen (radioshack) to remove the insulation enamel on the d0, alcohol is just for a dirty connection.
Logged

MeLv

  • Archived User
  • Newbie
  • *
  • Posts: 19
Problem With Matrix
« Reply #3 on: March 29, 2003, 08:37:00 AM »
QUOTE (Novahux @ Mar 29 2003, 05:03 PM)
QUOTE
cleaned the pogopins and the d0 with alcohol but nothing changes


Use a fiberglass pen (radioshack) to remove the insulation enamel on the d0, alcohol is just for a dirty connection.

do u have a picture of a fiberglass pen/radioshack cuz i can't imagine atm what it must look like. could b i have it @ my work.
Logged

taiko694

  • Archived User
  • Newbie
  • *
  • Posts: 2
Problem With Matrix
« Reply #4 on: March 29, 2003, 03:57:00 PM »
Ok that fiberglass pen is to remove the coating isn't it? can I scratch it a little bit in order to apear the metal circuit under it?
Logged

taiko694

  • Archived User
  • Newbie
  • *
  • Posts: 2
Problem With Matrix
« Reply #5 on: March 29, 2003, 06:13:00 PM »
Still..... NOTHING WORKS!!!!
Logged

DizzyT

  • Archived User
  • Newbie
  • *
  • Posts: 11
Problem With Matrix
« Reply #6 on: March 29, 2003, 11:52:00 PM »
Your matrix still isn't making the connection to the d0 point.  You can:
(1) Turn on the xbox and wiggle the matrix until it flashes green, then hold it in place and tighten the screw down.
(2) Manually solder a wire from the pogo pin to the d0 on the motherboard.
Logged