Topic: Removed Matrix , Xbox Wont Boot (Read 117 times)

smokeingit · « **on:** February 09, 2003, 09:05:00 AM »

um.... you removed and it you took out the washer right? i mean did you remove it while it was off? and when you put it back in does it work again?

valius · « **Reply #1 on:** February 10, 2003, 07:46:00 AM »

you usually get the flashing red light and a blank screen when you bridge or break a connection inside the xbox, did you muck around with the eeprom, tsop or anything?

energyBB · « **Reply #2 on:** February 15, 2003, 07:20:00 AM »

stil no luck, this sucks bigtime
i didnt screw around or fuck up
what could this problem be and how can i repair it?

lundell · « **Reply #3 on:** February 15, 2003, 07:58:00 AM »

i just got the same problem today...

And when i put my matrix in on on mode it works but say i have wrong HD wich i have hehe

I need help 2
i tried another bios and it wont work anyways...

smokeingit · « **Reply #4 on:** February 15, 2003, 09:43:00 AM »

energy, did you reflash your chip? but it sounds that maybe a wire came off. did you solder then hot glue?

lundell. your matrix is not either all the way down or get a better bios programmed.

lundell · « **Reply #5 on:** February 15, 2003, 09:49:00 AM »

Well thx for a great fourm

I found the answer after alot of searching

Author Topic: Removed Matrix , Xbox Wont Boot (Read 117 times)