Print

[smokeingit]

i was able to repair TSOP's that customers just erased and didnt program back. i fixed flash's with the wrong bios from cusomters... if you dont get the T1 wire right then it wong matter what you do. it will keep giving you hell. and the matrix fix does not work with 1.1 or 1.2

[cRaZy-X]

[Ceth]

QUOTE

I soldered a wire to the T1 point and got ready for the ground. Then I aligned the matrix (flashed with EvoX_MatriX_TSOP_flash.bin) to make the xbox flash orange/red/green in mode4. Then I ground the T1 point and switched the matrix over to mode3. After that, it just gives me the flashing red/green/orange lights. The stupid dvd tray wont even open (it makes a loud clicking sound over and over). Anyone know what Im doing wrong?

Basically when booting in MODE 3, nothing appears on the screen, DVD clicking sound and won't open, and eject led flashes green/amber/red intermittently.  MODE 2 & 4 render exact same results.  MODE 1, however boots original bios flawlessly, and DVD drive works as per normal.

Does this sound like an alignment issue?  I've tested my alignment with a DMM as stated in the diagrams... but I have no clue why it just won't boot anything.

[Ceth]

Allright I did make some improvement... I put the matrix into MODE 4 to test if its connected properly.  It took me a few tries but I got it.  However, instead of Green/Amber eject led flashing, I got a solid green led and the xbox booted the original bios!  Probably because this is the first time I'm flashing my TSOP.

So I switched matrix to MODE 3 and connected T1.  This time when powered on, it beeped then shut off.  It powered itself on again, beeped then shut off again.  It did it a third time, only it didn't shut itself down... it flashed Green/Red on the eject led.

Once again I'm clueless as to why.  Any suggestions?