Topic: Matrix Problems (Read 121 times)

echolizer · « **on:** January 16, 2003, 06:15:00 AM »

hi
this is probably due to
1. have u flashed your matrix with a bios yet?
2. try filling the lpc's with solder

those flashing lights indicate that your G-SPOT (d0) is correct, not to sure about your LPC's

hope this helps

farside · « **Reply #1 on:** January 16, 2003, 06:29:00 AM »

any other hint?

echolizer · « **Reply #2 on:** January 16, 2003, 06:30:00 AM »

wat bios are u using?

some bios only work on v1.1
so be aware of that

farside · « **Reply #3 on:** January 16, 2003, 06:37:00 AM »

i have an xbox v1.1 and im using D.6 eject fix...

now the box starts.. and he chip is green...
but.. a guy told me that i should see Matrix inside instead of the ordinary MS logo at the start...
is that right?

echolizer · « **Reply #4 on:** January 16, 2003, 06:40:00 AM »

farside · « **Reply #5 on:** January 16, 2003, 07:01:00 AM »

ok..
but is the chip alligend...
the problem is that the box doesnt read any cd-rw....
and now i reflashed the chip and it doesnt work again..
i get the red/green flashing eject button again....
ARGH this isnt fun anymore...

echolizer · « **Reply #6 on:** January 16, 2003, 07:04:00 AM »

try burning your cdrw at a slower speed
could even be your media

crl50384 · « **Reply #7 on:** January 16, 2003, 07:47:00 AM »

i also used a coloured version of evo-x d6 , just to make sure...

ramzez · « **Reply #8 on:** January 16, 2003, 07:50:00 AM »

Hi farside.

I have the exact same problem and I found the cause. When I start my xbox and press the matrix over the opposite side of the "matrix-screw ", the thing works. If I don't, then I have the problem. So I think it's all about alignment. I haven't yet been able to screw it into place so that it works without helping.

I hope this helps, and please post if you get it right.

Author Topic: Matrix Problems (Read 121 times)