xboxscene.org forums

Author Topic: Nfmus Do You Have To Desolder To Install Matrix On  (Read 55 times)

nfmus

  • Archived User
  • Jr. Member
  • *
  • Posts: 56
Nfmus Do You Have To Desolder To Install Matrix On
« on: December 28, 2002, 04:03:00 PM »

Most 1.1's don't have solder in the LPC.  Mine does but that doesn't really matter.  

It is my understanding that you can install the Matrix regardless of wether or not there is any solder in the LPC.  However there are some issues with determining good alignment that are specific to the 1.1.  I would recommend that you go to the Team Xodus site and read what they have to say about it.

You could also wait until the pogo pin adapter for the X2 is available and go that route.  But that is for you to decide.  Good luck.
Logged

XanTium

  • Archived User
  • Hero Member
  • *
  • Posts: 1358
Nfmus Do You Have To Desolder To Install Matrix On
« Reply #1 on: December 28, 2002, 04:10:00 PM »

QUOTE

Quick side note: The matrix installation manual will be updated ASAP regarding the alignment problems experienced with the v1.1 boxes. (For now rough guide is: any green flash no matter how quick, while booting the console, may be considered as a good alignment.) There are ways to obtain the green flashing, please bare with us while we finalize our tests.
Logged