Topic: The "if All Else Fails" Matrix+v1.1 Install Guide (Read 88 times)

aleph · « **on:** December 18, 2002, 08:10:00 AM »

Thank you for this useful guide/info!
I'll try your method with the solderpins.

majik655 · « **Reply #1 on:** December 19, 2002, 02:50:00 AM »

I Love this..

my two dumbass questions..
I am ASSuming you drop the balls of solder STICK down ? so the flatened side is facing up for the pins?

and last but not least.. You are not melting these points to the board correct? just kinda making little pads that sit there under the pins? stick down flat side up

THANK YOU!

jabthehut · « **Reply #2 on:** December 20, 2002, 12:19:00 PM »

Good luck to you all with your own chip installations!

JB

exide99 · « **Reply #3 on:** December 20, 2002, 07:40:00 PM »

Bluefear great idea (I still can't get bios to load goes green three times). Just to add if you use fingernail clippers you can form the pads and make the solder ball any size by trimming.

I don't know what to smash first the mod or the xbox!

bluefear · « **Reply #4 on:** December 21, 2002, 06:06:00 AM »

cheers and good luck,
bluefear

coolx · « **Reply #5 on:** December 21, 2002, 06:40:00 AM »

just wondering what an IGR is ?

knowledgeiv · « **Reply #6 on:** December 21, 2002, 08:19:00 AM »

QUOTE (coolx @ Dec 21 2002, 01:40 PM)

just wondering what an IGR is ?

IGR = In Game Reset

L+R+Back+Start from the controller resets the Xbox

xeviousx · « **Reply #7 on:** December 24, 2002, 06:14:00 AM »

Thanks Bluefear,

Been ripping my brains out until i saw your tut.

working afetr 20 mins

Razol · « **Reply #8 on:** December 24, 2002, 11:52:00 AM »

Thanx alot man, I finally got my matrix 2 work. (I just put some solder in the holes without heatening it just some small pieces).

Author Topic: The "if All Else Fails" Matrix+v1.1 Install Guide (Read 88 times)