Topic: Guide To Successful Matrix Install On A V1.1 (Read 78 times)

knowledgeiv · « **on:** December 16, 2002, 07:22:00 AM »

This seems like an excellent method for all those v1.1 users out there. Since I have only seem v1.0 so far, I have a hard time helping those with v1.1.

And if you don't mind, I would like to post it on my Matrix Tutorial Site to help others out; let me know if this is OK with you.

jabthehut · « **Reply #1 on:** December 16, 2002, 11:25:00 AM »

energyBB · « **Reply #2 on:** December 16, 2002, 12:42:00 PM »

PROPS il try ur tips right away
i so hope this wil work

Knuck3ls · « **Reply #3 on:** December 16, 2002, 01:10:00 PM »

I found that using a needle (not the sharp end) to test alignment worked very well, even on my v1.0 Xbox

Knuck3ls · « **Reply #4 on:** December 16, 2002, 03:14:00 PM »

Well, the 3 holes around the top most pogo pin, I will put the blunt side of the needle into, on each one with the Xbox powered off, and make it so its a snug fit, tighten matrix down, power on, Green!

Works everytime for me...

knowledgeiv · « **Reply #5 on:** December 16, 2002, 03:17:00 PM »

Author Topic: Guide To Successful Matrix Install On A V1.1 (Read 78 times)