Topic: Flash Tsop With Matrix + Evox (Read 572 times)

opjose · « **Reply #60 on:** November 13, 2002, 01:45:00 AM »

QUOTE (Zziggy00 @ Nov 12 2002, 07:49 PM)

you guys are gonna hate me

Let me try to ask this once again but wording it a little bit differently.

Lets say I attach all the wires, flash the TSOP successfully...

Can I remove ALL the wires that i placed in to flash the TSOP, INCLUDING the bridged jumper, remove the matrix from the box, close it back up and be able to run the xbox

OR

Do you NEED to leave the wires and jumper in to use the xbox with the newly flashed TSOP.

No need to remove the bridge jumpers, just the wires will suffice.

Yes you can remove the wires and close it up and the Xbox runs fine.

The only draw back to this is that you will not be able to reflash the bios.

If you leave the wires in, you can reflash it again WITHOUT(!) the matrix installed.

Remember if you screw up the flash though, you're going to be giving your Matrix away for the Xbox with the problems.

regulater7 · « **Reply #61 on:** November 13, 2002, 02:06:00 AM »

After you flash the TSOP with the matrix hack and it works 100%. Then you remove both wires. Cant you just bridge the other TSOP jumpers on the back of the motherbaord, and wont you still be able to flash the bios through evox, without any wires / chips..... or am i wrong??

opjose · « **Reply #62 on:** November 13, 2002, 07:39:00 PM »

QUOTE (regulater7 @ Nov 13 2002, 09:06 AM)

After you flash the TSOP with the matrix hack and it works 100%. Then you remove both wires. Cant you just bridge the other TSOP jumpers on the back of the motherbaord, and wont you still be able to flash the bios through evox, without any wires / chips..... or am i wrong??

Yes if you just bridge the two jumpers you WILL be able to reflash the TSOP, as long as YOU DO NOT use a retail bios.

opjose · « **Reply #63 on:** November 13, 2002, 07:40:00 PM »

QUOTE (steinola @ Nov 13 2002, 07:22 PM)

QUOTE (opjose @ Nov 11 2002, 01:25 PM)

It's an old Weller gun that I picked up a few years ago for about 15.00.

It's become my preferred iron for SMD work as the tip and length are so tiny.

The length of the iron is about the width of a soda straw (the metal part of the iron) and the handle is turquoise about the width of a pen.

Weller still makes 'em... though the retail price for new is ~ $35.

http://shop2.outpost.com/product/64252

Cool!

sebene · « **Reply #64 on:** November 15, 2002, 12:13:00 PM »

hi guys !

have a question ! do u still need to solder the 2 points ?
the one next to the chip and the other one behind the motherboard !
the points u need to solder when u have the old modchip!
thx

regulater7 · « **Reply #65 on:** November 15, 2002, 02:48:00 PM »

Yes? Can you just solder both jumpers and just the grounding wire?? have you tested this? if it work 100% someone plz tell me! not YOU KNOW IT WILL WORK, only if you have tested it.. Thanks!

Author Topic: Flash Tsop With Matrix + Evox (Read 572 times)