Topic: 29 Wires Mod On A V1.4 Xbox (Read 93 times)

MastaChef · « **Reply #30 on:** December 07, 2003, 09:12:00 AM »

oh man... thats gonna be a pain in the ass gotta unsolder the whole thing
ah well back to work

MastaChef · « **Reply #31 on:** December 07, 2003, 09:20:00 AM »

before i start removing this thing what do i do with "link to 32"/pin 33 and pin1/a18?
thanks

Ozmods · « **Reply #32 on:** December 07, 2003, 11:48:00 AM »

ypu don't need to use A19

you need to Link 32 to E on the board..If you don't do that it won't work..

1.4 and 1.5 should look the same

I have used Evox and xecuter 4979 and they both work for me

What chip are you using?
Is it a 512K?
have you flashed it with the correct size bios?
And have you checked the pinout on you chip to match the chip that is shown?

MastaChef · « **Reply #33 on:** December 07, 2003, 12:50:00 PM »

im using a 29c020 it is 256k and i flashed it with 4979 256k so that should be good right?
i have pin 31/we 24/oe, 22/ce, 16/vcc and "pin33"/ link to 32 connected to ground is this correct?
pin 32 connected to the +5v on the lpc debug
when i boot the xbox it boots to the ms bios

MastaChef · « **Reply #34 on:** December 07, 2003, 12:56:00 PM »

i noticed that pin 32 goes to the lpc debug 5v but i herd that this is disconnected in the 1.5 is that true?
and if so where can i get 5v from?

MastaChef · « **Reply #35 on:** December 07, 2003, 01:14:00 PM »

tried alternate source for 5v (same one that xecuter uses for 1.5 board) and still have the same problem

Author Topic: 29 Wires Mod On A V1.4 Xbox (Read 93 times)