xboxscene.org forums

Author Topic: [enigmah] Xbox Errors  (Read 71 times)

BredaNL

  • Archived User
  • Newbie
  • *
  • Posts: 2
[enigmah] Xbox Errors
« on: July 20, 2002, 11:04:00 AM »
Ok I just installed my Enigmah chip. everything went fine, all wires are soldered nicely, but when I turn on my xbox it tries to start up 2 times and then flashes green-red...Now could the problem be that I didn't solder a jumper yet for my bios version (4034) ? If so Ill do that tomorrow 1st thing, or is something else wrong?                    
Logged

Drew826

  • Archived User
  • Sr. Member
  • *
  • Posts: 340
[enigmah] Xbox Errors
« Reply #1 on: July 20, 2002, 12:32:00 PM »
my jumper came pre-soldered. i assume you need to have it connected for everything to work                    
Logged

anonnie

  • Archived User
  • Newbie
  • *
  • Posts: 18
[enigmah] Xbox Errors
« Reply #2 on: July 20, 2002, 12:59:00 PM »
I ran into that before, and for me it was because i had an open on one of my contacts, if its not the bios version, check your wiring.                    
Logged