Print

[3tlk]

Should be the same as my homebrew, so yes, some should be semi-conductive.  On the home brew point 16 and 32 should be semi-conductive.

Then 32 and 32 are linked together for FlashROM.  And I believe it is 22 and 24 that are linked to point 16.

[sfbaymod]

I think Colppy is talking about a conductivity test from solderig pad to the other end of the wire on the mod chip.??    if this is the case 165 is too high ..  it should be under 7 or so..  

see if you solder wires to the wrong soldering pad on xbox.  
did you check if system works after you fix pad that was pulled off ? ..

remove mod chip .. check if still works..   if re-mod..  

if not .. well .... have fun ..  : )