Topic: Psone Lcd (Read 34 times)

dougMod · « **on:** June 07, 2005, 05:27:00 PM »

I wired it up and all using Sword Fish's tut and i was able to get the screen to run off of 5v and when i get a picture on the screen its always black and white. From the flubber to the games. Did i do anything wrong?

dougMod · « **Reply #1 on:** June 08, 2005, 07:12:00 AM »

flashfreak · « **Reply #2 on:** June 08, 2005, 07:51:00 AM »

found this, may help u:

"You have to enable High Def A/V Mode to get the option for progressive scan in the MS dashboard. Using High Def A/V Mode with the S-Video cable should work, though you may not have color (the "Green" or "Y" signal is enabled in all modes, which supplies the video in black and white)."

http://forums.xbox-s...ic=213487&st=30
Post #37.

I dunno if it'll help or not, but it says black and white. Maybe that tut tells u to connect to the "Y" instead of normal composite?

Its sounds about right. Good luck

dougMod · « **Reply #3 on:** June 08, 2005, 04:19:00 PM »

thanks man ill let you know

dougMod · « **Reply #4 on:** June 08, 2005, 06:58:00 PM »

I tryed enigma and it didnt do anything and i dont know how to do the enable the High def in M$ dash

dougMod · « **Reply #5 on:** June 09, 2005, 07:30:00 AM »

TB_88 · « **Reply #6 on:** June 09, 2005, 10:52:00 AM »

lol the psone lcd is only for composite video?
So why try HD modes? doesn't support them...
blacka and white probobly because the lcd only support PAL, not PAL60... or NTSC only??

dougMod · « **Reply #7 on:** June 09, 2005, 06:28:00 PM »

its an NTSC screen..

dougMod · « **Reply #8 on:** June 09, 2005, 10:49:00 PM »

didnt have enough power

The Zep Man · « **Reply #9 on:** June 09, 2005, 10:57:00 PM »

QUOTE(dougMod @ Jun 9 2005, 03:41 PM)

bump

Author Topic: Psone Lcd (Read 34 times)