Topic: Vga Mode - Internal Sync V/h (Read 85 times)

-Zou- · « **on:** April 24, 2004, 08:04:00 AM »

!!!

nickepooo · « **Reply #1 on:** April 25, 2004, 07:32:00 PM »

Hey i just completed a successful vga port mod on my xbox and here are the sources i used.
http://www.xboxnation.info/id17.html
nice pin layouts of the motherboard\avip port and mode selection info

http://xbox-linux.so...s/howtovga.html
has the wiring configs for the schmitt trigger, and where to pull the sync's off the motherboard.

I dont check the forums much, but if you need help email me. [email protected]

ideas_man69 · « **Reply #2 on:** April 26, 2004, 08:12:00 PM »

you have an email mate..

if ANYONE else has been able to find the point on the motherboard, could you please post a pic of them here. ive been searching for ages but i can't be sure of any pads on the motherboard. your help would be greatly appreciated.

cheers.

nickepooo · « **Reply #3 on:** April 27, 2004, 05:59:00 PM »

Here they are

http://home.comcast....olderpoints.jpg

http://home.comcast.net/~nbold/ide.jpg

http://home.comcast....~nbold/done.jpg

http://home.comcast....~nbold/rear.jpg

the only problem I faced with this mod is that the vga connector on the back is too close to the avip port. Not a biggie, I just shaved off some of the plastic on the monitor cable. I have 1 week of classes left, if i have time sometime soon i will try to write up a tutorial.

EvilWays · « **Reply #4 on:** October 03, 2004, 01:01:00 PM »

There are solder pads (albeit small ones) close to the xGPU. Xbox-Linux has pics that I can verify are on a v1.0 mobo (I don't have a 1.1 to check).

Author Topic: Vga Mode - Internal Sync V/h (Read 85 times)