Topic: Flashing The Xboxs TSOP by SniperKilla (Read 20 times)

themenace · « **on:** July 10, 2002, 05:10:00 AM »

Hi,

I've read SniperKilla's tutorial about flashing the xbox bios to evo2.2 but he mentions that you would need switches....as I don't know where to get these here in my location is it possible just to cut the 2 wires of the xtender chip when you normally would put the switches open according to SniperKilla?
If the flash is succesfull you wouldn't need the xtender chip anymore, right?

-->
If your chip was a ST chip, make a c:\roms on your xbox and put the evo2.2 bios in it found on the evolution x release.

Then load up the evolution x dashboard, go to system utilities, then flash bios.

Open both switches off position *** or cut the wires???***

Then open your ftp program, browse to c:\roms, then execute :
flashbios name.bin
Replacing name with whatever your bin name is.
There should now be a bar on your tv showing the progress of flashing.

It will tell you its rebooting, leave the mod switches open, if the evolution x dashboard loads, it was successful, try booting a backup.

You can then remove the mod or leave the switches open.

fedepctv · « **Reply #1 on:** July 10, 2002, 07:41:00 AM »

But is necessary to cut all the wires of the mod chip or just someone (for example VCC line etc..)?
Thanks

themenace · « **Reply #2 on:** July 10, 2002, 09:29:00 AM »

You only need to cut 2 two wires or build switches between them.
See the tutorial:
Flashing the xbox tsop

gggie · « **Reply #3 on:** July 10, 2002, 01:08:00 PM »

)

this switch installation thing sounds safer than cutting wires while the xbox is on -- but, heck, i don't even know what a switch looks like never mind how to install one... (is it terribly difficult?)

Author Topic: Flashing The Xboxs TSOP by SniperKilla (Read 20 times)

Author Topic: Flashing The Xboxs TSOP by SniperKilla (Read 20 times)