xboxscene.org forums

Author Topic: Evox Boot Disk  (Read 81 times)

line1260skr

  • Archived User
  • Newbie
  • *
  • Posts: 3
Evox Boot Disk
« on: December 07, 2004, 01:55:00 PM »
So basically second xbox im doing. Finally after buying new dvds got the thompson drive to read the bios xecuter2 pops up in place of MS when chip is on. So next step evox boot disk....So i burn evox.ini and default.xbe? or xboxdash.xbe? along with a dummy file around 100 mb to cd-rw or dvd-r i also tried dvd+r  those files and also the skin folder and it should pick it up....but as i remember from my last xbox doesnt go as plan anyone have any ideas on why it wont boot from the cd the orignial hard drive is in chips enabled and says xecuter 2 but boots to MS dashboard....im stumped just say xbox cannot read disk under MS dash......hmm help!!! :)
Logged

karob29

  • Archived User
  • Newbie
  • *
  • Posts: 5
Evox Boot Disk
« Reply #1 on: December 07, 2004, 02:56:00 PM »
:D This is my first post since I joined!  Anyways after reading a ton of posts in general and about your same problem I figured a very easy and quick way around this.  It's more of a "workaround" then a fix.

Use any cd/dvd drive(from your PC most likely) and power it either by...

*Using a 4prong female power splitter so you can split the power cable currently being used by the hard drive to also power the cd/dvd drive (you can get a splitter from most any pc shop for a dollar or two)
*Use any PC power supply and just hook it up temporarily to power the cd/dvd drive.

That will get your EvoX installed without all the wasted cds/dvds and time burning and trying different media's and such.  I personally think that is so much easier and afterwards just swap in your stock dvd drive and you are back in business.

I'm not sure what you where asking about burning.  When you burn the EvoX disk there is no need for a dummy file.  The iso is all you need.  Sorry if that's not what you where looking for.   :blink:

This post has been edited by karob29: Dec 7 2004, 11:05 PM
Logged

Trash_Master

  • Archived User
  • Newbie
  • *
  • Posts: 5
Evox Boot Disk
« Reply #2 on: December 08, 2004, 12:45:00 PM »
i have tryed with the dvd drive but it wouldnt work !!

any jumper settings that i need to set or is it just as cs ??
Logged

karob29

  • Archived User
  • Newbie
  • *
  • Posts: 5
Evox Boot Disk
« Reply #3 on: December 08, 2004, 03:16:00 PM »
Yes set the jumper on the DVD to cable select and it should work fine.  Did you try the setup I suggested?  Explain a little more about what you are doing and i'm sure someone here can help you out.
Logged

Trash_Master

  • Archived User
  • Newbie
  • *
  • Posts: 5
Evox Boot Disk
« Reply #4 on: December 10, 2004, 12:01:00 AM »
i got it to work but the jumper was set to slave !! and the hdd to cable select !! but wtf !! it worked !!
Logged