xboxscene.org forums

Author Topic: Security Level Maximum After Error 16  (Read 224 times)

ldotsfan

  • Archived User
  • Hero Member
  • *
  • Posts: 2072
Security Level Maximum After Error 16
« on: August 10, 2008, 08:02:00 AM »
Try hotswapping with dvd ide cable disconnected.
Logged

ldotsfan

  • Archived User
  • Hero Member
  • *
  • Posts: 2072
Security Level Maximum After Error 16
« Reply #1 on: August 10, 2008, 08:19:00 AM »
What does LiveInfo say about the security state of the hdd?

Are you using xplorer360 to read the hdd contents or with xboxhdm after the hotswapping?

What are the jumper settings of the xbox hdd?
Logged

ldotsfan

  • Archived User
  • Hero Member
  • *
  • Posts: 2072
Security Level Maximum After Error 16
« Reply #2 on: August 10, 2008, 08:52:00 AM »
Read this again: http://forums.xbox-s...howtopic=332179

DaddyJ's comments:
CODE

**If you are doing a hotswap in BLIND mode (No tv hooked), then I found in my experience, that if your using the Error 12 method, that you should disconnect the Xbox HD IDE at the exact moment that the LED goes to RED Flashing. (By EXACT, I mean pull the cable out exactly when the LED changes, watch it a few times before doing it, count!)
I have never had any problems hotswapping at this exact moment.


You are not doing the hotswapping correctly.

The jumper positions should be indicated on a diagram on the hdd somewhere.
Logged

openmc

  • Archived User
  • Newbie
  • *
  • Posts: 1
Security Level Maximum After Error 16
« Reply #3 on: August 10, 2008, 09:25:00 AM »
I Did IT!!!!!!!!!!!
I'm Jumping for happiness  biggrin.gif jester.gif  biggrin.gif

I was hotswapping in blind mode without the TVcable plugged in the xbox. Now its obvious: it doesn't works.
I've done it in blind mode with the TV cable plugged in (without TV) and it worked!!!!
Thanx very much to ldotsfan.

Sorry for bothering...
Logged