Topic: No Error Code! Help! (Read 31 times)

merlin008 · « **on:** February 28, 2008, 07:58:00 AM »

I have a v1.0 and flashed the tsop. Everything was fine... went to florida for a five day vacation and got back plugged it in and now it boots to the call customer service screen with no error code. It loads the x2 bios and then THE SCREEN! anyone got and advice?

? thanks

1hotjob · « **Reply #1 on:** February 28, 2008, 09:45:00 AM »

Can you boot Slayer's or a game disk?

merlin008 · « **Reply #2 on:** February 28, 2008, 10:13:00 AM »

no game disc no AID, now it seems to not even get to the bios and go directly to that screen>

lordvader129 · « **Reply #3 on:** February 28, 2008, 12:04:00 PM »

are you sure its loading the x2 bios? that should have an error code

the stock 1.0 bios doesnt though, did you have you TSOP split at all?

merlin008 · « **Reply #4 on:** February 29, 2008, 09:55:00 PM »

it goes flubber then no code error screen... no split...

Bomb Bloke · « **Reply #5 on:** March 01, 2008, 05:59:00 AM »

Open the console up, check the IDE cable.

If replugging that has no effect, unplug the DVD drive and see if that makes a difference.

merlin008 · « **Reply #6 on:** March 01, 2008, 12:40:00 PM »

checked my tsop solder points and found that C7D2 is not there and no where to be found..... YIKES can i just bridge the two points???

Author Topic: No Error Code! Help! (Read 31 times)