xboxscene.org forums

Author Topic: Wiikey Pin 6  (Read 168 times)

bigjay8510

  • Archived User
  • Jr. Member
  • *
  • Posts: 60
Wiikey Pin 6
« on: August 05, 2008, 12:33:00 PM »
I finished all the other points, but I messed up pin 6 is there an alternate point for pin 6?
Logged

bigjay8510

  • Archived User
  • Jr. Member
  • *
  • Posts: 60
Wiikey Pin 6
« Reply #1 on: August 06, 2008, 10:20:00 AM »
does this right? i wasn't sure if this was it because these are different solder points

IPB Image
Logged

bigjay8510

  • Archived User
  • Jr. Member
  • *
  • Posts: 60
Wiikey Pin 6
« Reply #2 on: August 06, 2008, 06:51:00 PM »
the different solder points that i use where the ones according to this guide...

http://www.ps2cover....nstallation.pdf

what happened was i got sloppy when soldering pin 6 and basically there is no solder left on pin 6 (not on the wiikey on the board).  so can i just run pin 6 from the wiikey to leg 8 on the ic chip?
Logged

bigjay8510

  • Archived User
  • Jr. Member
  • *
  • Posts: 60
Wiikey Pin 6
« Reply #3 on: August 06, 2008, 10:42:00 PM »
i wired to the ic chip (pinout 8) when i turn on the wii everything is fine, but the dvd drive is not spinning up.  i have checked al the connections...
Logged

bigjay8510

  • Archived User
  • Jr. Member
  • *
  • Posts: 60
Wiikey Pin 6
« Reply #4 on: August 25, 2008, 01:27:00 PM »
I connected pin six to the 8th leg with some small wire and its working like a champ.
Logged

DimitroffVodka

  • Archived User
  • Newbie
  • *
  • Posts: 2
Wiikey Pin 6
« Reply #5 on: September 05, 2008, 05:18:00 PM »
So Happy I came upon this thread. I did the same thing but on point 3. What guage wire did you use to solder on the IC chip?
Logged

swampy1111

  • Archived User
  • Full Member
  • *
  • Posts: 109
Wiikey Pin 6
« Reply #6 on: September 06, 2008, 09:12:00 AM »
use 30swg kaynar
Logged