Topic: Soldering? (Read 70 times)

Oscar_the_Grouch · « **on:** August 28, 2005, 04:28:00 AM »

Is it possible to have 2 seperate mods at the same time that share 1 or more similar solder points?

Synops · « **Reply #1 on:** August 28, 2005, 04:47:00 AM »

i would think so.... as long as the soldering is done well. but you would have to have a switch on the D0 i think, a single pull, tripple throw? middle is off(no mod) up is 1 chip, down is the other chip. try it out, i want to knwo hwo it goes

networkBoy · « **Reply #2 on:** August 28, 2005, 10:48:00 AM »

Yes it is, though I'm not sure of the wiring for some of the more advanced chips.
On the old cheapmods you would simply switch which chip got the #Frame signal. On the alladin and related clones you should be able to switch the BT point between chips. As to the Xecutors, Xeniums and other do-everything chips I know you could switch power, but I don't know about the other stuff.
-nB

Oscar_the_Grouch · « **Reply #3 on:** August 28, 2005, 01:24:00 PM »

Oh this isn't an xbox, sorry. It's a gabeboy advance sp. The overclock chip and a dimmer chip. They both perform different functions. Is there a way to have them both running without switches so I could use them at the same time? My soldering is fine, but knowledge in electronics isn't the greatest. Sorry I posted this here but it seemed to be the most appropiate forum where I could get the proper response.

lordvader129 · « **Reply #4 on:** August 29, 2005, 08:31:00 AM »

this is an xbox forum, so i wouldnt count on getting too much help with a gba

BuddyLeeX · « **Reply #5 on:** August 29, 2005, 09:54:00 AM »

networkBoy · « **Reply #6 on:** August 29, 2005, 11:31:00 AM »

QUOTE(BuddyLeeX @ Aug 29 2005, 05:29 PM)

wow

what he said.
-nB

Author Topic: Soldering? (Read 70 times)