Print

[wilgo45]

This can either be a failed Mosfet.

A shorted Power Reg

A blown 0.0 ohm resistor

A bad ROL board component - this is what the touch sensitive strip ties into.

A failed touch sensitive strip

Or - a power brick that has lost one of the 12 volt feeds.  Power brick will still light the LED with the standby 5 volts still active.  So that could be throwing you off.  Try your Slim brick on a friend's Slim.  That will give you a starting answer.

Can you provide any more details - given the situation ?

[WherEmEweeD]

I have taken the board out now. I'm not 100% sureo n how to test the mosfets but i have my eye on two which i think are the common ones for blowing but i'm still not sure how to test them.

I have a multi-meter an all and i know the name of all the connectors the two mosfets.

as for the resistors i'm not sure how to test them either lol



Will be tomorrow before i can test another touch board on the xbox and wired controller.

The two powerbrick works fine so do the outlets.

[wilgo45]

Mosfets have to come off the board for proper testing

Hot air desoldering works best to lift them