Topic: Rrod, 0110, What Would Be Best? (Read 64 times)

dragonfire665 · « **on:** November 11, 2011, 01:49:00 PM »

any thoughts?

Gokussj5okazu · « **Reply #1 on:** November 11, 2011, 03:14:00 PM »

Well most notably, you should NOT buy a heatgun and use it However, you SHOULD send it to someone capable of reflowing and or reballing the RAM or GPU is it needs it. The heatgun way is very old, flawed, and practically abandoned. I do not recommend it even the slightest.

dragonfire665 · « **Reply #2 on:** November 14, 2011, 07:52:00 AM »

Thanks guy. I might be going that route, finding someone to reball it for me since thats as far as my knowledge will go and neither will i want to learn. It seems like lots of work. But one thing, should i wait for the extreme uniclamp, they will be in tomorrow, since i already paid for them and see what happens?

MadMaxGR · « **Reply #3 on:** November 14, 2011, 08:40:00 AM »

QUOTE(dragonfire665 @ Nov 14 2011, 04:52 PM)

Thanks guy. I might be going that route, finding someone to reball it for me since thats as far as my knowledge will go and neither will i want to learn. It seems like lots of work. But one thing, should i wait for the extreme uniclamp, they will be in tomorrow, since i already paid for them and see what happens?

No matter if you do the perfect x-clamp fix/replacement, you will need to properly reflow the GPU first. otherwise you will get the error once again.

shambles1980 · « **Reply #4 on:** November 14, 2011, 10:11:00 AM »

0110 is usualy ram related as pointed out it can be gpu also or a trae between the gpu and ram.. and i would not be suprized if its related to the south bridge.
As mentioned please for the love of everything holy dont use a heatgun on it.
The best you can hope for with a heat gun is that you dont manage to reflow the solder properly but some how you warp something so its back in contact with the board..
most of the time when i see a 360 that some 1 had used a heatgun on they managed to make the solder balls flow together and create 0020 errors and i wont even bother to fix those, i just strip it down take off all the chips and sell them.
theres a small chance that reflowing a 0020 error will fix it 1/30? 1/100? "slim to none?", but i wont bother to reflow or reball them because if you managed to heat the solder up enough for it to run like a liquid you probably burnt out some traces too.. not to mention damage that could have been done to the chips. Not worth my tiime to find out.

dragonfire665 · « **Reply #5 on:** November 14, 2011, 12:40:00 PM »

this is one knowledgeable freaking site. Holy stuff. Kudos to all. Thank you for warning me and making sure i dont fryi my board.

Author Topic: Rrod, 0110, What Would Be Best? (Read 64 times)