Print

[paveynick]

QUOTE(Wilhelm_I @ Aug 13 2008, 02:45 PM)

However I dont think both of your 360s will work for long since you only got it to work by overheating them not with the pressure...
Use the heatgun when it returns

Hate to say it, but you were right. That's me gone again, had a 5 hour session on Saturday night, just turned it on, froze and 3 red lights.

Heat gun it is then.

[karlgent]

Hopefully the heatgun works for you. I'm going to try heat gun tonight, my cousin got me a 2000W gun from his work so hopefully that will work.

I haven't tried the card fix on the chips but since I was getting error 0110 before freezing, I'm just gonna go straight for the heat gun.

Good luck

[Wilhelm_I]

QUOTE(karlgent @ Aug 19 2008, 09:00 PM)

Hopefully the heatgun works for you. I'm going to try heat gun tonight, my cousin got me a 2000W gun from his work so hopefully that will work.

I haven't tried the card fix on the chips but since I was getting error 0110 before freezing, I'm just gonna go straight for the heat gun.

Good luck

Concentrate on the RAM and GPU mate, the cold solder joint is somewhere there.
And follow my heatgunning tutorial thorughly, it will take like 2 hours in total but then it will be fixed for sure...
Take care that you dont flex the mainboard once you are done be very carefully while removing the isolation and putting it back in the case etc...

[karlgent]

Okay will do, cheers for that mate. I had a read over your tutorial a few times and it looks good, I'll report back on my success.

Cheers