Print

[ej2095+1]

Hi all

Not been on here in a very very long time (too much time over at XDA Devs lol)

Just bought my son a 360 as hes being eyeing up my backups which are gathering dust atm..

and a lite on 16d2s drive (Lastest firmware on system so i assume drive is updated)

I have the xecutor ck3 board and a probe 1

Can this be altered so that i can extract the key from this drive?

I read some where about fitting a switch??

All help appreciated.

[iateshaggy]

all u have to do is add the switch to the #6 wire in the dvd power cable, use the probe as in, just on the new probing spot.

[dougiegillam]

QUOTE(ej2095+1 @ Jan 3 2013, 01:12 AM)

Hi all

Not been on here in a very very long time (too much time over at XDA Devs lol)

Just bought my son a 360 as hes being eyeing up my backups which are gathering dust atm..

and a lite on 16d2s drive (Lastest firmware on system so i assume drive is updated)

I have the xecutor ck3 board and a probe 1

Can this be altered so that i can extract the key from this drive?

I read some where about fitting a switch??

All help appreciated.

Download tutorial here.
http://www.mediafire...77sonsvxzgw99m3

[UnnA^]

Yeah, it is dead easy. Just cut the wire that goes to point 6 on the 2 plugs and put a switch on it!

Here's my converted probe v1 which i have successfully dumped heaps of drives with.

[ej2095+1]

So will do switch in a moe

So all i do is connect probe to point mk01 thingy

with 3v on hit phatkey extracts and toggle the power and it should should dump the key?

Take it reads via the sata connection?

[ej2095+1]

Forgot to say thanks for above input!!

i just re read my post and it reads very rude lol

appolgies for this but thanks once again for all input

[ej2095+1]

Done it

Probe was being stupid so i just did it the bodge way

used a length of solder wrapped on pc case to make the ground and did the usual steps

all worked great

then flashed and tested all fine

got a happy 7 year old now (who thinks hes going to hoard all my backups) (only got about 30 to be fair lol)

[kaneda_77]

Didn't see this post. I take it that the mod on a diygadget probe is similar. As far as I can see the pogo pin is connected to the power cable. I will have to get some pics up of mine. Thanks for all the info. Been a while since I missed mine.