xboxscene.org forums

Author Topic: Spoofing Confusion?  (Read 88 times)

chrissyd

  • Archived User
  • Newbie
  • *
  • Posts: 20
Spoofing Confusion?
« on: June 15, 2011, 05:56:00 AM »
I have a 360 that had a lite-on in it originally, the drive motor went so i replaced the lite-on with a benq and spoofed it as lite-on.Works a treat. New MS update released , flashed the benq back to stock fw (benq stock) did the update, then flashed benq 1.9lt no spoof and it works .Why does it not need spoofing?
Logged

ichigoxxx

  • Archived User
  • Full Member
  • *
  • Posts: 136
Spoofing Confusion?
« Reply #1 on: June 15, 2011, 08:48:00 AM »
the update made it new original drive , thats been answer on the FAQ.
Logged

tomgreen99200

  • Archived User
  • Hero Member
  • *
  • Posts: 826
Spoofing Confusion?
« Reply #2 on: June 20, 2011, 02:23:00 AM »
If you had a spoofed drive and made the update, that update should have failed (according to everything i have read.) I'm a little confused too, maybe someone knows more.
Logged

chrissyd

  • Archived User
  • Newbie
  • *
  • Posts: 20
Spoofing Confusion?
« Reply #3 on: June 20, 2011, 02:29:00 AM »
I didnt just have the one spoofed either both benq spoofed as lite-on , after updating with orig benq firmware no need to spoof 1.9 lt , used benq 1.9 ? I couldnt find anything in the faq`s on the new update about this?
Logged

dennisv9

  • Archived User
  • Full Member
  • *
  • Posts: 102
Spoofing Confusion?
« Reply #4 on: June 20, 2011, 06:08:00 AM »
QUOTE(tomgreen99200 @ Jun 20 2011, 10:23 AM) *

If you had a spoofed drive and made the update, that update should have failed (according to everything i have read.) I'm a little confused too, maybe someone knows more.


i have read the same all around, the update should have failed

QUOTE(chrissyd @ Jun 20 2011, 10:29 AM) *

I didnt just have the one spoofed either both benq spoofed as lite-on , after updating with orig benq firmware no need to spoof 1.9 lt , used benq 1.9 ? I couldnt find anything in the faq`s on the new update about this?


so if you tried to update your xbox that originally had a liteon, which you replaced with a benq that is spoofed as a liteon, ==> then the update should have failed. as the poster above also replied.

on the other hand, if you didn't spoofed your drive (which isn't necessary at all after the/since the 9199 dash), the update should have failed too i believe. unless the dash doesn't care that the osig doesn't match up (=a liteon is expected, but a benq is really found) and flashes the drive it actually is there nonetheless (but this would seem risky and a flag is most likely).
Logged