Print

[justice91423]

QUOTE(podger @ Apr 15 2011, 11:15 AM)

OK, I'm not entirely sure where it went wrong on the first attempt..

BUT

if ctrl + shift + f9 worked its certain JF has been here before..

try this

1. Power cycle
2. ctrl + shift + f9
3. Slimkey
4. *** say NO ***
5. should intro and grab key etc and save a dummy.bin

//

Well that worked.  I'm hesitant to flash it since I'm not doing a full FW read and someone has been poking around this drive before me.  Any thoughts on risks?

[podger]

Risks: are ever present...

not sure what you mean "someone", as you have not really mentioned the circumstances under which the drive arrived with you...

Obviously if you have a spare 9504 handy, you could flash that and test..

if not.... well

does the Key "look" ok, as in, no multiple 0x00, 0x77, 0xff, 0x5A  etc

was there any message during the extract that would lead you to believe it didn't go swimmingly ??

if you load the dummy as source and LT as target, spoof, does the target key verify ??

Does the drive play games now ( unlikely on latest dash in any case with 3e000 modified )....

In source "Serial" tab, does the barcode on line 1 match the barcode on the drive label...

//

This post has been edited by podger: Apr 15 2011, 11:35 AM

[justice91423]

Well caution to the wind I went ahead an wrote and all seems to be fine.


Thanks for all your help.

[podger]

Yay \o/

good news.... just a pity it took so long getting it all sorted...

This post has been edited by podger: Apr 15 2011, 01:20 PM

[Ubergeek]

Jungle Flasher FTW. Again.  

[ruben182]

QUOTE(podger @ Apr 15 2011, 11:15 AM)

1. Power cycle
2. ctrl + shift + f9
3. Slimkey
4. *** say NO ***
5. should intro and grab key etc and save a dummy.bin

//

What do you mean with step "3. Slimkey" ?
Thanks to ctrl + shift + F9 I finally seem to be able to intro.
But when I read I always get "Unknown f/w!"

[Rammieone]

QUOTE(ruben182 @ May 28 2011, 01:53 PM)

What do you mean with step "3. Slimkey" ?
Thanks to ctrl + shift + F9 I finally seem to be able to intro.
But when I read I always get "Unknown f/w!"

Using the latest Jungleflasher there should be a tab button saying SlimKey hit that at step 3 mate

Here you go mate

[ruben182]

QUOTE(Rammieone @ May 28 2011, 01:59 PM)

Using the latest Jungleflasher there should be a tab button saying SlimKey hit that at step 3 mate

Here you go mate

Haha! Thanks for the super fast reply!
I was looking in the MTK Flash tab  
Everything worked perfect!

Other question: Should I be able to do a full dump with only my Maximus Xtractor? Or is this only possible with this Slimkey dump?