Topic: Lite On 93450c Boxxdr (Read 34 times)

peterson99 · « **on:** February 02, 2020, 05:07:00 PM »

Ok, so i have soldered the wires, 22 ohm resistor, and switch to the board using a DPDT switch. However when i plug the the drives power in (using the ck3 lite), nothing happens, and the red light on the ck3 disappears. Just wondering if anybody know why this happens?

iateshaggy · « **Reply #1 on:** February 02, 2020, 05:13:00 PM »

because you got solder all over your board.

Takashi · « **Reply #2 on:** February 02, 2020, 05:14:00 PM »

Pictures help, otherwise we're flying blind

peterson99 · « **Reply #3 on:** February 02, 2020, 05:54:00 PM »

how do you upload a picture thats on your computer, onto one of these posts? i apologize but i cant figure out how

Takashi · « **Reply #4 on:** February 02, 2020, 07:09:00 PM »

photobucket preferably

peterson99 · « **Reply #5 on:** February 03, 2020, 04:32:00 PM »

http://s1095.photobucket.com/albums/i467/p...¤t=100_1428.jpg
http://s1095.photobucket.com/albums/i467/p...¤t=100_1427.jpg

Sorry if the pictures aren't the best my camera kinda sucks.

Takashi · « **Reply #6 on:** February 03, 2020, 04:34:00 PM »

Bad angle, but still, I can see 3-4 possible areas that would short easily, way too much solder used.
Also, the wire gauge is just too big.
Edited Pic

This post has been edited by Takashi: Today, 12:40 AM

peterson99 · « **Reply #7 on:** February 03, 2020, 05:23:00 PM »

what wire gauge would you recommend me using?

Takashi · « **Reply #8 on:** February 03, 2020, 05:28:00 PM »

30 gauge Kynar works well

This post has been edited by Takashi: Today, 01:28 AM

Author Topic: Lite On 93450c Boxxdr (Read 34 times)