Print

[shane3673]

I have a lite on 9xxxxxx and a LT-SW V2 Clip in dos flash it says
Manufacturer ID: 0xC2
Device ID: 0x11
Name: MXIC/Marconix(MX25L2005)
Size: 262144 bytes
Type: Serial with Status 0x72
Name: PLDS DG-16D2S
Firmware Revision: 93450C

but when i do the liteOn DvdKey it doesent work and if i do a regular read it says the firmware file is invalid in JF What am I doing wrong

[Takashi]

What do you mean "Do the dvdkey"?

[shane3673]

its an option on dosflash to read the dvdkey for a lite on it saves 3 files but i get a error when i run it

This post has been edited by shane3673: Dec 25 2010, 06:03 AM

[iateshaggy]

try the read command instead

[shane3673]

the read command acts like it works but then when i try to open it with jf to add the spoof it says the firmware is invalid

[shane3673]

also i am using windows 7 and have never got jf to work for reading any drive but have flashed a benq with no problems with dosflash just using jf to create the frimware

[shane3673]

does anyone have any suggestions I dont think the cuts are bad cuz when i leave the switch on normal and put the box back together i still plays movies and games

[Svantesson666]

Redo the MRA hack.

1. Put the switch in ON-mode
2. Power on the drive
3. Start JungleFlasher
4. Go to "MTKFLASH"-tab and click "Intro" and powercycle
5. Get Status 0x72
6. Put the switch in OFF-mode
7. Click "Read"

Now you got your firmware without dealing with DOSFlash.

Or do it in DOSFlash, perhaps you forgot to put the switch in OFF-mode?

[Ranger72]

Really should dump that LT-Switch thing and do it the right way. Boxxdr would be a good start.

You wont be getting 3 files with the MRA method. You want the complete firmware dump. You should be using Jungle Flasher for this.