Print

[Chrushev]

Setup:
Liteon 360 with LT firmware on it (not LT+)
Nforce chipset SATA
Xbox Powered Drive
Win7-64bit

Here are the steps im doing:

1) Everything is off
2) Turn on Xbox and eject the drive
3) Press Eject and as drive is half way in I pull the power from back of the drive, and then plug it back in. Drive stays half way open and the xbox green front light is blinking..
4) Turn on PC, BIOS sees the drive
5) In Windows 7 64 bit run Jungleflasher it sees the drive
6) Try to do INtro, fails... try to cut power to drive and replug in while its sending intro no go... just gives code 0x52.

I have also tried same steps but with DosFlash.. same thing.. cant send intro. What am I doing wrong?

[Ranger72]

I assume you already have your drives original dump info such as dummy.bin and you have already created the proper LT+ firmware and all you are doing is just erasing and flashing the drive right?

[Svantesson666]

Why are you clicking intro?
All you need is to load your old firmware that I hope you saved. Spoof source to the LT+ firmware and then go and click "Lite-On Erase". Clicking intro won't do you any good as JungleFlasher sees the drive already. Then of course you are gonna have to power cycle and that doesn't sound too easy as you have your Xbox as power source.

And btw, you don't need to have your drive in half open. That was to read your key originally but since you updated it to LT that is gone too. Point is, it doesn't matter what mode the tray is in when you write new or erase an old firmware.

[Chrushev]

QUOTE(Ranger72 @ Dec 2 2010, 02:46 PM)

I assume you already have your drives original dump info such as dummy.bin and you have already created the proper LT+ firmware and all you are doing is just erasing and flashing the drive right?

Yeah I have the files. I havent done this in a year though and dont remember how to do it.  What I did was in top field selected the one that was flashed to the drive a year ago and in the bottom new LT+ then clicked spoof top to bottom.. thats all I have to do right?

QUOTE(Svantesson666 @ Dec 2 2010, 02:48 PM)

Why are you clicking intro?
All you need is to load your old firmware that I hope you saved. Spoof source to the LT+ firmware and then go and click "Lite-On Erase". Clicking intro won't do you any good as JungleFlasher sees the drive already. Then of course you are gonna have to power cycle and that doesn't sound too easy as you have your Xbox as power source.

And btw, you don't need to have your drive in half open. That was to read your key originally but since you updated it to LT that is gone too. Point is, it doesn't matter what mode the tray is in when you write new or erase an old firmware.

So the drive doesnt have to report 0x72 anymore?

[Ranger72]

Try a STICKY

[Chrushev]

QUOTE(Ranger72 @ Dec 2 2010, 03:04 PM)

Try a STICKY

yeah so I did what the sticky said.. but that doesnt help me... should the drive be reporting 0x72 or does it not matter? if it matters.. how do I get it to report 0x72?

[Ranger72]

QUOTE(Chrushev @ Dec 2 2010, 07:08 PM)

yeah so I did what the sticky said.. but that doesnt help me... should the drive be reporting 0x72 or does it not matter? if it matters.. how do I get it to report 0x72?

Click the liteon erase button in the MTK Flash 32 tab.