xboxscene.org forums

Pages: 1 [2]

Author Topic: Hit A Brick Wall With The Liteon 93450c  (Read 90 times)

b0xel

  • Archived User
  • Newbie
  • *
  • Posts: 7
Hit A Brick Wall With The Liteon 93450c
« Reply #15 on: February 03, 2020, 12:42:00 PM »
will do, thanks for all the help guys. I'll let you know what happens next...
Logged

ken D.

  • Archived User
  • Newbie
  • *
  • Posts: 26
Hit A Brick Wall With The Liteon 93450c
« Reply #16 on: February 03, 2020, 06:16:00 PM »
Buzzcut how did you write the firmware Or flash after repairing the pcb traces on the board, it should be the same process right??

I've tried to re-flash my liteon 9c drive with all the traces repaired..but I I'm having a hard time putting it into vendor mode, using my xbox power...never can get status:0x72? it's easy getting the flash chip properties when doing the boxxdr method with all the wire at the same time I retrived my DVD key and then flash.

I was wondering if you can help me with that? can you tell me exactly how you did that, and the steps?
I'm curious if this might be the problem..

This post has been edited by ken D.: Today, 02:17 AM
Logged

TorchMach1

  • Archived User
  • Jr. Member
  • *
  • Posts: 56
Hit A Brick Wall With The Liteon 93450c
« Reply #17 on: February 03, 2020, 06:40:00 PM »
Using a lower value resistor than 20 ohm seemed to help the times I had trouble getting LO firmwares to dump.  Try lowering resistance to 18 ohms and see if it helps.
Logged
Pages: 1 [2]
« previous next »