xboxscene.org forums

Author Topic: 93450 Won't Go Into Vendor Mode  (Read 20 times)

mcastleberg

  • Archived User
  • Newbie
  • *
  • Posts: 15
93450 Won't Go Into Vendor Mode
« on: July 20, 2010, 04:19:00 PM »
the clip is giving me green light for good trace cuts but my multimeter gives a reading between the 2 points with arrows for some reason.  i can't get into vendor mode and keep getting error 0x51 in JF...any ideas based on this picture?


(IMG:http://i772.photobucket.com/albums/yy6/mcastleberg/xbox/toupload2.jpg)

Logged

iateshaggy

  • Archived User
  • Hero Member
  • *
  • Posts: 906
93450 Won't Go Into Vendor Mode
« Reply #1 on: July 20, 2010, 04:48:00 PM »
those spots should have continuity.  can't really help you w/ clip issues, i recommend you go get a 22 ohm resistor and tear up a cat5 cable.
Logged

mcastleberg

  • Archived User
  • Newbie
  • *
  • Posts: 15
93450 Won't Go Into Vendor Mode
« Reply #2 on: July 21, 2010, 09:17:00 AM »
can anybody else weigh in on how my cuts and PCB prep look?
Logged