xboxscene.org forums

Author Topic: Mra Hack Liteon Fw7485 Device Intro Failed Status 0x51 - Help  (Read 51 times)

saleem_hacks_360s

  • Archived User
  • Full Member
  • *
  • Posts: 150
Mra Hack Liteon Fw7485 Device Intro Failed Status 0x51 - Help
« on: March 14, 2010, 08:07:00 PM »
you say you power off the drive then intro and on.that is not the way to do it unless i am missing something.

you open jungleflasher,then with the switch on the board in on posistion (i dont use switch i just hook the wires together) power the drive,then hit device intro,the status always shows chip properties for me,then switch to off posistion or wires unhooked and reintro the drive one more time.

then read the drive or board.

this has been answered so many times yet people always keep asking,its like so often,like daily it is ridiculous.

 blink.gif  

Logged

iateshaggy

  • Archived User
  • Hero Member
  • *
  • Posts: 906
Mra Hack Liteon Fw7485 Device Intro Failed Status 0x51 - Help
« Reply #1 on: March 15, 2010, 08:15:00 AM »
check your resistor w/ a multimeter to be sure it actually is 22 ohm.
Logged

saleem_hacks_360s

  • Archived User
  • Full Member
  • *
  • Posts: 150
Mra Hack Liteon Fw7485 Device Intro Failed Status 0x51 - Help
« Reply #2 on: March 15, 2010, 08:25:00 AM »
read boxxdr thread as that is best troubleshooting thread as it covers the mra dump proceedure and your question as been asked at least 50 times just there at minimum.

 smile.gif  

Logged

jrizvi99

  • Archived User
  • Newbie
  • *
  • Posts: 4
Mra Hack Liteon Fw7485 Device Intro Failed Status 0x51 - Help
« Reply #3 on: August 31, 2010, 08:07:00 AM »
Use the exact 100% same method as MRA hack. Cut the tracks and configure the wiring as descrbed. Then follow the steps below exactly.

Remember if you are getting status 0x51 or 0x52 you need to cut deeper tracks and Check your wiring.

Once all done use this method.

Power off to drive
Switch set to 3.3v
Start JungleFlasher
Select MTS tab
Click on Intro button
Click 'Yes'
Now Power the drive ! - Not before.
It should take less than a few seconds for it to load status 0x72 - If not

Now flip Switch to resistor - Very important or you will get parsed failes!!!!! DO NOT USE FW !!!! it has NO KEY
Click Read
Save
Spoof
Write
Outro

Done! Disconnect machine half assemble and test.


Go back and check the tracks, check your soldering and then your wiring config

I have used 22 omh and 20 omh resistors . Both work amazingly fine.

Dont forget ! never give up ..its not the board its you! so double check your work.

In case you are freaking out and getting furstrated becuase a 20 min job has now turned into multiple hours over multiple days... It is still your mistake. So dobule , triple check your work.

I guarantee that once done 100% same as MRA hack , and then follow my steps

Jay

www.godsofmods.com

http://www.facebook.com/#!/group.php?gid=111154092263921
Logged