xboxscene.org forums

Author Topic: Dummy.bin Question For Liteon  (Read 45 times)

dcarnie8269

  • Archived User
  • Newbie
  • *
  • Posts: 6
Dummy.bin Question For Liteon
« on: February 08, 2010, 03:21:00 PM »

I just flashed my liteon 74850c from LT back to stock using jungleflasher's guide (loading the previous dummy.bin). Everything went great. Now, I actually want to use IX1.61 (already banned, dont care), can I use this same dummy.bin instead of using my ck3 probe. It has all the data including my key, the only thing Im worried about when I went to load it is that it mentioned the FW that was loaded at the time the dummy.bin was made (ix1.6) when in fact, right now it is stock. Would this really matter? or is it the the key and other drive specific info that it looks at? Thanks in advance for any input
Logged

igotwormz

  • Archived User
  • Newbie
  • *
  • Posts: 23
Dummy.bin Question For Liteon
« Reply #1 on: February 02, 2020, 06:47:00 PM »

you should just stay with LT or 1.6 non stealth just for the purpose of reading all future waves. I don't think 1.61 will read wave 5 once it's out. I could be wrong though.
Logged

grimreaper204

  • Archived User
  • Newbie
  • *
  • Posts: 28
Dummy.bin Question For Liteon
« Reply #2 on: February 03, 2020, 05:54:00 PM »

It just looks to make sure the DVD key is correct so yes you can use the dummy.bin as the key source and just spoof to 1.61 firmware, 1.61 plays all waves so you are better off going for that since you are already banned.
Logged