xboxscene.org forums

Author Topic: Eject Button  (Read 111 times)

squeek

  • Archived User
  • Jr. Member
  • *
  • Posts: 67
Eject Button
« on: October 08, 2004, 11:15:00 PM »
i looked at the tuts here and everything in the hardware forums but i dont wanna screw this up so i just wanna verify with people.      

do i just cut or de solder the 3 led points on the board and then basically put the grounds together in the middle and the two powers on the top and bottome? or what i dont wanna mess this up  <
Logged

altec

  • Archived User
  • Full Member
  • *
  • Posts: 103
Eject Button
« Reply #1 on: October 08, 2004, 11:20:00 PM »
the best way is here
xbox-scene front-led
 <
Logged

TB2ZI

  • Archived User
  • Jr. Member
  • *
  • Posts: 77
Eject Button
« Reply #2 on: October 09, 2004, 01:54:00 AM »
Check my sig for another (and in my opinion better) tut.  :D Happy modding :D   <
Logged

altec

  • Archived User
  • Full Member
  • *
  • Posts: 103
Eject Button
« Reply #3 on: October 09, 2004, 01:55:00 AM »
that works too B)  B)   <
Logged

el_diablo

  • Archived User
  • Sr. Member
  • *
  • Posts: 388
Eject Button
« Reply #4 on: October 09, 2004, 01:59:00 AM »
peronally, i would just cut them, saves alot of time  <
Logged

bleugh

  • Archived User
  • Sr. Member
  • *
  • Posts: 373
Eject Button
« Reply #5 on: October 09, 2004, 03:14:00 AM »
done about 12 of these now and cut them every time,
I then use two 3mm LED's that i've sanded down so they both dont take up much more space than the 3mm that was already fitted,

no case modification needed! and you can have ANY colour you want  <
Logged